Toshiba Satellite C50D-BM0010 (issue)

 

Toshiba Satellite C50D-BM0010 (issue)

Issue

Solution-

It is recommended that you calibrate your battery every few months. This involves draining the battery until the laptop goes to power off on its own, then recharging it to 100%.

Procedure

First, charge your battery up to 100 % and let it rest for two hours without leaving the laptop plugged in. This process makes sure the battery is cool while charging although you can still use it while charging.

 Option #1:

1. Click the battery icon located in the lower right corner of your laptop. Click "more power options" to access your computer's power management settings in the Control Panel.

2. In the Power Management settings, click the "Choose when to turn off the display" link found at the left side corner.

Comments

Post a Comment

Popular posts from this blog

Tecra C50-C1513 (Power Jack Issue)

Image
Tecra C50-C1513 (Power Jack Issue) Power Jack Issue Solution = One of the most troublesome common problems faced by Toshiba satellite users is the power jack. This issue can be easily identified when the laptop losing contact between the motherboard and the positive pin. To fix this issue, users have to disassemble the laptop and remove the motherboard and resold the positive pins of the power jack to the motherboard. When the monitor graphics are distorted or do not show properly, then users of Toshiba laptops can troubleshoot the problem before buying a new graphics card as well as taking their laptops to any service repair company, they can try to fix the problem by taking some steps that are given below. See here for fixing Toshiba
Read more

Wireless connection problems Toshiba Satellite Pro A40-CX4100

Image
  Wireless connection problems Toshiba Satellite Pro A40-CX4100 Wireless connection problems Solution = The lack of details about your computer and Operating System makes it very hard to give you a good thorough answer. You might want to reinstall the drivers, or even delete and then reinstall the drivers. If it's windows you need to go into device manager and delete the information about the wifi device, and then start the installation process for the drivers for that device. If it's Linux, then you need to try using the ifconfig command. To access its information you can type at the command line, “man ifconfig”. You would probably have to sudo into the root to be able to do anything with the Wi-Fi devices. Sometimes it's just a matter of turning off all Wireless, or even all networking, and then reactivating it again. With Windows, the equivalent is to disable the network device and then re-enable it. In Windows, you may have to disable networking ...
Read more